reheat steam
英 [ˌriːˈhiːt stiːm]
美 [ˌriːˈhiːt stiːm]
网络 再热蒸汽
双语例句
- The temperature of reheat steam directly influences the efficiency of a power station.
再热蒸汽温度直接影响电站的经济性。 - Reheat steam cooling section of pipeline;
再热蒸汽冷段管道； - Boiler Reheat Steam Temperature Control Based on State Variables Approach via H_ ∞ Technology
基于H∞的锅炉再热汽温状态变量的控制 - In tangential combustion system, the reheat steam temperature can be adjusted by changing burner nozzle angle to just the flame position.
在切向燃烧系统中，通过改变燃烧器喷口的角度可以调节炉内火焰中心位置，可达到调节再热汽温的目的。 - Modeling Research of the Reheat Steam Temperature Based on RLS Adaptive Filter
基于RLS自适应滤波器再热汽温建模研究 - The simulation results indicate that power system low frequency oscillations of resonance mechanism might be caused by the pulsation of turbine's main steam pressure or reheat steam pressure, when their pulsating frequency is consistent with or close to power system natural oscillations frequency.
仿真分析表明，汽轮机主蒸汽压力和再热蒸汽压力脉动，当其脉动频率与电力系统自然振荡频率一致或相近时，均有可能引起电力系统发生共振机理的低频振荡。 - The influence of fresh steam pressure and reheat steam pressure undulations on the torque in turbine-generator rotor strings during fast valving has been studied and calculated by numerical simulation.
通过数字仿真研究，计算了快关调节阀中主蒸汽压力脉动和再热蒸汽压力脉动对汽轮发电机轴系扭矩的影响。 - Study on power-correcting calculation for performance degradation of reheat steam turbines
再热汽轮机性能老化对功率的修正计算研究 - A new casade feedback control system with load feed forward of reheat steam temperature is proposed in this paper.
提出了一种新型具有负荷前馈&串级反馈的再热蒸汽温度控制系统。 - Analysis and Suggestions on the Regulation Method for Reheat Steam Temperatures of Tieling Power Plant
铁岭发电厂调节再热汽温方法的分析和建议 - Off-Design Performance of IGCC with Dual Pressure and Reheat Steam Cycle
双压再热蒸汽循环的IGCC变工况性能 - This article mainly introduces and analyzes the flow-path features of air-cooled condensing reheat steam turbine, and discusses the advanced design of the flow-path and aerodynamic design features of the last stage blade.
主要总结和分析了600MW中间再热空冷凝汽式汽轮机通流部分的特点，重点介绍了机组通流部分设计的先进性和空冷末级叶片的气动设计特点。 - The exergy analysis of an intercooled reheat steam injected gas turbine cycle has shown that such a cycle has a significantly higher exergy efficiency as compared with a simple STIG cycle.
对中冷再热注蒸汽燃气轮机（STIG）循环火用分析结果表明：中冷再热STIG循环比简单STIG循环的火用效率显著提高。 - The application of Model Algorithmic Control ( MAC) in power plant ′ s boiler reheat steam temperature control is described and the result of a simulating study of MAC on reheat temperature control is given.
论述了模型算法控制（MAC）方法在电厂锅炉再热汽温控制中的应用及其仿真研究的结果。 - Analysis on dynamic error and research on real-time arithmetic models for reheat steam unit in on-line performance monitoring.
中间再热式机组性能在线监测中的动态误差分析及实时算法模型研究。 - Improving on the Defining Method of Reheat Steam Turbine Ideal Cycle Thermal Efficiency
中间再热式汽轮机理想循环热效率定义方法的改进 - The reheat steam temperature regulated by tilting burner for 600 MW utility boiler was described in this paper.
介绍了600MW电站锅炉利用摆动燃烧器调节再热汽温的特性。 - A Study of the Reheat Steam Temperature Regulation Methods for Large-sized Boiler Units
大型机组再热汽温调节手段研究 - Analysis on Dynamic Error of Heat Rate for Reheat Steam Turbine in On-Line Performance Monitoring
中间再热式汽轮机热耗率在线监测中的动态误差分析 - Calculation on Loss of Pressure for Tubes of Main Steam and Reheat Steam and its Optimized Layout
主蒸汽和再热蒸汽管道压降计算及布置优化 - Research on model predictive control of reheat steam temperature for large scale coal-fired units
大型燃煤机组再热汽温模型预测控制研究 - The Application of Fuzzy PID Control Method on Reheat Steam Temperature Based Perturbation Analysis
基于扰动分析的再热汽温模糊PID控制方法研究 - Through optimization operation test of a 670t/ h boiler, the authors systematically analyze the reasons for low temperature of reheat steam, and bring forward the method of unit optimization operation.
通过对一台670t/h锅炉优化运行方式的试验，系统地分析了再热蒸汽温度偏低的原因，提出了机组的优化运行方式。 - Analysis and Prevention of Water hammer in HRSG Reheat Steam Piping
HRSG再热蒸汽管道中的水击现象分析与预防 - Tests on ball mill system with nonlinear coupling and reheat steam temperature with large time constant, large delay using steam-steam exchanger show that multivariable control strategies developed have important theoretical and practical advantage for process control of power plant.
非线性多变量球磨机对象和具有大惯性、大时滞耦合的汽-汽交换器多变量再热汽温对象上仿真结果证实，本文的研究对丰富火电厂多变量对象的控制具有重要理论意义和实用价值； - Drainage System Retrofit of Main and Reheat Steam Pipes for 200 MW Turbine
200MW汽轮机主、再热汽管道疏水系统的改造 - Application of MICRO-Z distributed control system to a reheat steam temperature control system
Micro-Z集散控制系统在再热蒸汽温度控制系统中的应用 - Investigation of a Method for Correcting the Performance Test System of a Reheat Steam Turbine
再热汽轮机性能试验系统修正方法研究 - As an example of reheat steam temperature system in thermal process, PLS modeling method based on historical data is proposed.
以热工过程中的再热汽温系统为例，介绍了基于历史数据的PLS建模方法应用过程。